Fastcap 2P-10 - Part-1 Jel Adhesive - 10 Oz

Fastcap 2P-10 - Part-1 Jel Adhesive - 10 Oz

2P-10 can be used on many materials including melamine! - The surface should be clean, with no oil

2P-10 products can be submerged in water! - The adhesive must be completely bonded and DRY beforehand. All of our adhesives would work fine in a boat setting if applied correctly. You must make sure that both surfaces are dry and clear of debris before application.

HOW TO USE 2P-10:

PART ONE - The Adhesive - comes in Four Viscosities: Thin, Medium, Thick, and Gel™ plus Rubber-Toughened in Gel™ and Thick viscosities.
PART TWO - The Activator - comes in a spray or bottle and sets and hardens the adhesive.

Apply the adhesive, then spray the activator and stick it together for a strong, permanent bond. 2P-10 can be used on many materials as long as they are clean and the surface is well prepared. The surface should be clean, with no oil. If the surface is slightly etched, the glue will bite more eFaceframeectively. While it should not be used in lieu of a weld (on metal), 2P-10 is very eFaceframeective for tacking, to hold a piece in place for welding.

Which Viscosity Should I Use?

• Thin - designed for wicking into hairline cracks
• Medium - designed for wicking into 1/8 in. cracks
• Thick - excellent gap-filling capacity, great for binding joints, ideal for filling holes
• Jel™ - excellent for filling large gaps, great for trim carpentry, will not run
• Rubber-Toughened Thick - provides elasticity to joints and is 10% stronger than standard 2P-10 Thick
• Rubber-Toughened Jel™- provides elasticity to joints and is 10% stronger than standard 2P-10 Jel™

Related Products as part of the gluing system:

• 2P-10 Colorant - when filling in large holes or cracks, colorant can be used to match surrounding color.
• 2P-10 Debonder - helps remove drips of cured adhesive from most surfaces