Snappy 3/8 Countersink Bit with 3/16 Standard Point Pilot Drill
Snappy 3/8 in. Countersink Bit with 3/16 in. Standard Point Pilot Drill
Make It Snappy® Gold-Screw™ Countersink w/Standard Point Pilot Drill
Tired of countersinks that slip on the drill bit after one or two holes? After tightening the set screw half a dozen times, the drill bit is usually so scarred up that there is no hope of any further adjustment. These countersinks are designed so that the countersink locks onto the hex shank instead of the drill bit itself - slippage is eliminated!
Drill a pilot hole and countersink or counter-bore for standard screws.
Note: When selecting the right size countersink, certain sizes of pilot hole drills specify the clearance hole size. A clearance hole will allow a screw to pass through it without the threads biting into the material.
See SPECS tab for details.
| Plug Outside Diameter | 1/2" |
|---|---|
| Drill Diameter | 3/16 in. |
| BRAND | Make It Snappy |
| Countersink Type | Standard |
| Point Type | Standard |
| Shank Type | HEX, ball detent d |
| QUANTITY | (1) Each |
| SKU | MS-3312 |
| SPECS: | SPECS:
|
| Prop 65 |
|
WARNING: While working in a hazardous areas where you can be exposed to flying objects, fragments, and particles, primary protective devices such as safety glasses or goggles with side shields must be worn. Secondary protective devices such as a face shield is required in conjunction with primary protective devices during severe exposure to impact hazards.
WARNING: Drilling, sawing, sanding or machining wood products can expose you to wood dust, a substance known to the State of California to cause cancer. Avoid inhaling wood dust or use a dust mask or other safeguards for personal protection. For more information go to www.P65Warnings.ca.gov/wood.
Login and Registration Form