Milescraft DrillPump300

Milescraft Drill Pump 300

The DrillPump300™ is designed to work with most electrical drills with a maximum speed of 2,800 RPM, with an output of at least 600 W. This water transfer pump is ideal for draining small ponds, fish tanks, small pools, or even a flooded basement. The hose connection is 1/2 in. and uses any 1/2 in. hose. The unit pumps up to 300 gallons per hour and is self-priming up to 9 feet. The 3/8 in. shank on this unit fits all common chucks for most drills.

DrillPump300™ Features:

• Pumps up to 300 gallons (1,300 liters) per hour
• Self-priming up to 9 feet
• 3/8 in. shank on this unit fits all common chucks
• 1/2 in. hose connection

Tips & Tricks:

• The power drill may only be operated in clockwise rotation, never run DrillPump300™ in reverse
• DrillPump300™ will not turn by hand; this must be chucked to the drill
• DrillPump300™ must be mounted for proper usage, do not hold in hand
• The hoses should be in good condition, include a gasket, and be completely tightened for priming
• After every use, apply a small amount of silicone grease. To apply, remove the black housing screws and cover, and put a bit of grease on the housing where the rubber fan blades touch, then reassemble. Any spray lubricants, such as WD-40, are not recommended, as they do not provide sufficient lubrication for this product and can cause damage to the internals of the pump.
• Do not get the drill wet, or use the drill pump with flammable liquids.
• The direction of flow is indicated by an arrow on the housing.
• The delivery rate can be regulated by the speed of the power drill.