6-10 1/4 Drive 1 In. Grabit Bits/Screw Removal Tool

6-10 1/4 Drive 1 In. Grabit Bits/Screw Removal Tool

OPERATING INSTRUCTIONS

Burnishing:

1. Insert Grabit directly into drill or quick change chuck - Burnishing end showing (cutting end)
2. Set drill for reverse (COUNTERCLOCKWISE)
3. Place Burnishing end of tool into damaged screw, slowly clean inside screw head until smooth. Note: Burnishing tool end is not to be used to drill hole.

Removing:

4. Remove Burnishing end from chuck, flip tool, replace into drill chuck--Remover end now showing (spiral end)
5. Maintain reverse setting (COUNTERCLOCKWISE)
6. Place Remover end of tool into smooth screw head.
7. Apply firm downward pressure, drill at slow speed. Apply lowest level of power to hand drill.
8. Remover end of Grabit will thread into screw head and remove.