#2 x 1-15/16 in. Reduced Shank Square Drive Bit Ball Detent

Buy 6 and Save

Has your driver bit ever destroyed the wood surface around a countersunk #4 or #6 screw? Standard Power Driver bits are sometimes too large to fit into a 1/4" diameter countersunk hole to drive a recessed screw. When that happens, the driver bit body makes a mess of the wood surrounding the hole. Normally, this is only a problem when using a 1/4" diameter countersink with #4 and #6 screws.

The solution is quite simple - use a driver bit with a reduced shank. That way the bit tip can reach the screw without creating an unsightly mess.

• One-piece bits are usually a disappointing compromise between the need for a hardened tip and a durable body.
• Special Iso-Temp heat treating process makes these the toughest one piece bits available
• reduced shank nose can reach just a little farther into a countersunk screw hole without damaging the wood.