Read our Privacy Policy.
Back to Normal View
When you really need to put some torque on a screw, or you need to work in tight quarters, these can be a life saver. Just pop the adapter onto your 1/4", 3/8" or 1/2" drive ratchet, and slip in a 1" long hex insert or power driver bit. Made in USA.
REVIEW SNAPSHOT®
(based on 5 reviews)
40%
of respondents would recommend this to a friend.
Pros
Cons
Best Uses
Reviewed by 5 customers
Sort by
Displaying reviews 1-5
Back to top
Solved a problem with an low power drill
By rg
from Des Plaines IL
About Me Beginner
See all my reviews
Comments about Ratchet Drive Adapter for 1'' Hex Insert or Power Driver Bits:
Was looking to buy a heavier duty drill to drive long screws.My existing drill would not finish the job. This will allow me to drive the occasional long screw without getting a new drill
would not buy again
By pops
from Bismarck ND
About Me Casual Do-It-Yourselfer
Comments about Wiha Ratchet Drive Adapter for 1'' Hex Insert or Power Driver Bits:
used 1/4" drive adapter once and retaining spring came out along with impact bit. bits will now fall out of adapter. more involved to return than item is worth.
The spring does not hold the bits in.
By Square drive Tom
from Micanopy FL
About Me Avid Do-It-Yourselfer
Use for driving square drive screws in close quarters.
Did not work
By sol
from Del Rio Tn
The small clip that holds the 1/4 inch bit came out to weak to hold the bit had to tape adapter to keep bit in it. Was going to use it to drive screws with air impact.
good product
By steve
from boca raton,fl.