Have you ever cut trim moulding for what you thought was a perfect 90 degree corner, only to discover a big gap at the miter? Corners are not always square, even when they should be, making it a bit tricky to set the saw angle. Even when the angle is measured correctly, there is often a bit of calculation involved to set the saw. The Angle Fix miter guide’s incredibly innovative design provides an easy way to set the saw angle for perfect miters every time! Just place the two legs on either edge of outside or inside corners, transfer the Angle Fix to your miter saw, then place the saw blade against the alignment tab. The tab is automatically one-half of the angle measured, so you don’t need to do any mental gymnastics to set the blade. Works with hand or power miter boxes. Angle Fix is made of glass-fiber reinforced plastic, and measures approximately 10-1/2" long, with a body height of 3/4" and arm width of 1-7/8". The alignment tab is 1-7/8" x 3/4" high. Made in Sweden.
(based on 2 reviews)
Reviewed by 2 customers
Displaying reviews 1-2
Back to top
(1 of 1 customers found this review helpful)
Angle Fix is a Winner
from St Thomas PA
About Me Avid Do-It-Yourselfer
See all my reviews
Comments about ANGLE FIX Miter Guide:
Add a locking device so the measurement can't change from when the measurement is made to when it is transferred to the miter saw.
Bottom Line Yes, I would recommend this to a friend
Was this review helpful? Yes / No
- You may also flag this review
from Malvern, AR
About Me Professional
This is the slickest angle finder I have ever seen. Protractors are OK, but you have to calculate and dial in the angle. This device makes it sooooooo much easier. Set and saw. Great for crown moulding.