Read our Privacy Policy.
Talk about convenience! When you need to change bit sizes, just pop the bit out of the drill chuck, flip it around, tighten the chuck, and you are ready to go again. Be careful when putting these in your drill though. The internal workings of some drill chucks have a tendency to eat the end that is in the chuck if inserted to full depth! These bits have a standard 1/4 hex body and are approximately 1-1/2 long. Please note: these are only designed for use directly in the drill chuck - they do not have a ball or wire detent and do not fit the 4-in-1 Hand Drivers!
REVIEW SNAPSHOT®
(based on 1 review)
Reviewed by 1 customer
Displaying review 1
Back to top
it would be better if 1 inch longer.
By NO NICKNAME
from ATHENS, AL.
About Me Avid Do-It-Yourselfer
Pros
Cons
Best Uses
Comments about #1 and #2 Double Ended Square Drive Bit:
the product slides too deep into my power tools. it would be perfect if it were 1 inch longer.