Read our Privacy Policy.
Back to Normal View
Secure trim molding or roofing paper
Built for high performance with power and a quick air-recycling time, these staplers are ideal for light trim moldings, drapery cornices and roofing underlayment paper. Despite their small size and lighter weight, they don’t sacrifice power or quick air recycling time making them high performance tools. They perform at relatively low air pressures and operate at 20-40% lower air consumption than most competing models. Each features a patent pending trigger valve, rear exhaust, an easy pull-up magazine latch and a heavy steel head cap that also works as a hammer. The GRX-2116AD is similar to the GRX-71AD except it uses the Senco A Series staples, while the GRX-A11AD uses Arrow T50 and Rapid A11 series staples. Imported.
Specifications:
REVIEW SNAPSHOT®
(based on 1 review)
Reviewed by 1 customer
Displaying review 1
Back to top
Puts electric stapler to shame!
By Neighbor
from Wellsboro Pennsylvania
About Me Avid Do-It-Yourselfer
Pros
Cons
Best Uses
Comments about Grex 20 Gauge Stapler:
I installed radiant floor heat to a new house and was stapling bubble foil insulation to the underside of the tubing. I started out with an Arrow T50 stapler but that was going to take forever and it was very difficult to use. I then purchased an electric stapler and that wasn't much better. I knew I needed something better and after reading the reviews on the Grex staplers, I purchased one. Wow oh wow! This stapler drives the staples flush everytime and was an absolute joy to use. Only word of caution is that there is no contact safety, which was good for me but you can shoot staples anyplace you want to. For where I was working (above my head), this was perfect! Compact, quick and powerful and it uses very little air. I was running my compressor from a generator and found out I only needed to run it long enough to pump up my 20 gallon air compressor. I could then staple for an hour - probably about 1000 shots. It will drive the longer (1/2 inch) staples as easy as 1/4 inch. I also found out it would easily fasten the aluminum heat plates in place as good as the 1/4" narrow crown staples I had already used. I look forward to using this stapler again!