These heavy-duty drive shafts flex through 90 degrees (or more depending upon the length) to help you reach those “inaccessible” screws easily. Unlike other “flexible extension shafts”, the outer cover of these extensions does not rotate, so you can hold it as needed to direct it into position, and you don’t need to worry about it grabbing hold of something unexpectedly. Just imagine how nice it would be to snake one of these flexible extensions deep into an appliance and remove a screw without taking half of the machine apart first! Torque capacity of 156 inch-pounds is almost twice as much torque as a #10 screw can take! Standard 1/4" ball detent drive end fits most quick-change chucks. The mag-bit holder female ends accept both 1/4" ball and wire detent tools and bits. The shaft is .42" while the insert bit coupling has a diameter of 5/8"(.625"). Made in Taiwan.
(based on 5 reviews)
of respondents would recommend this to a friend.
Reviewed by 5 customers
Displaying reviews 1-5
Back to top
PERFECT FOR VINYL RAIL/POST INSTALL
By HAMMER DOWN HOWARD
from LYNCHBURG, VA.
About Me Avid Do-It-Yourselfer
Comments about 11'' Flexible Extension Shaft:
I OWNED ONE OF THESE FLEXIBLE SHAFTS BEFORE BUT OVER TORQUED IT TRYING TO LOOSEN A HEAVY DUTY SCREW ON MY LAWN TRACTOR. MY STUPIDITY. NICE TO HAVE IN TOOLBOX.
Bottom Line Yes, I would recommend this to a friend
Was this review helpful? Yes / No
- You may also flag this review
Best of the Best!
By Chief Bill
from Windsor, CT
I use this to remove screws that are normally inaccessible when used with conventional shafts. This shaft allows easy removal and doesn't break like most of the flexible shafts that don't allow you to remove screws. They are only designed for forward use. What a fantastic design!
Don't leave home without it
By Doctor Bob
from New Hampshire
Proved invaluable recently building a deck without sufficient clearance near house for driver
Good for difficult places
from Orange, CA
About Me Professional
Worked well up to #8 screws if predrilled. After a few uses on 3" long #10 screws the product failed. Replaced by McFeely no problem. Have used the replacement unit on #8 screws to 2 1/2" with no problems. The ability to bend the shaft lets you install scews tight to corners without the need to angle the screw head out.
A MUST HAVE
from CLENDENIN, WV
I USE THIS PRODUCT EVERY DAY IN INSTALLING KITCHENS