Back to Normal View
Looking for a waterborne lacquer with the warmth and depth of a nitrocellulose product? Look no further! Not only is it abrasion resistant, it’s self-leveling properties make it easy to use, and an almost imperceptible amber cast gives it the natural look of a traditional lacquer. Three degrees of sheen are available in CrystaLac top coat: Gloss (90), Semi-Gloss (60) and Satin (30). Top coats are compatible with all other CrystaLac products except Floor Finish (Polyurethane). Topcoats should not be tinted. Coverage: approximately 125 square feet per quart. This slow-drying formulation discourages air bubbles from forming during application, and allows any that do form to diffuse on the surface.
Available in Satin, Gloss and Semi-gloss in Quarts and Gallons. Satin Quart is pictured.
(based on 2 reviews)
Reviewed by 2 customers
Displaying reviews 1-2
Back to top
By The Finisher
from Arlington, TX
About Me Professional
Comments about Quart Gloss Brushable CrystaLac:
I have used many products over the years but this one is the best. Follow directions-gentle fine grit sanding knocks down the raised grain to render the smoothest finish. Its low odor and water clean-up is a plus. The surface resists scratches. I have used it on fine custom-made furniture with mulitple wood species,cypress for bathroom wall/trim,and baseboards. I use a special fine brush and good lighting.
Bottom Line Yes, I would recommend this to a friend
Was this review helpful? Yes / No
- You may also flag this review
(1 of 3 customers found this review helpful)
Test before using.
from Argos, IN
About Me Avid Do-It-Yourselfer
See all my reviews
Followed directions on can exactly. Product raised the grain. Fuzzing and grain raise was really bad on end grain cuts and routs. Thankfully, I tested the product on wood scraps from my project. Although, the water cleanup was nice, I'll be sticking with traditional oil based stains and finishes.
Bottom Line No, I would not recommend this to a friend