Back to Normal View
Dual thread design eliminates volcano effect left by most screws in composite decking
The TrapEase II screws are approved for use in composite decking as well as ACQ and CA-B pressure treated wood. The zinc plated TrapEase II screws are guaranteed not to rust or streak in these materials when installed correctly. Screws should be driven slightly lower than flush with the deck surface. The dual thread draws the composite material back into the screw hole resulting itn a smooth finish. The heads of the screws are #10 trim and require the use of a #1 Square Drive bit. Point is a gimlet point with a cutting notch. Not for use within 1,000 feet of salt water or on decks where de-icing salt will contact the deck. Available in 100 sq. ft. (350 screws) and 500 sq. ft. (1,750 screws) decking packages. One driver bit is included with each package. Made in Taiwan and coated in the USA.
(based on 1 review)
Reviewed by 1 customer
Displaying review 1
Back to top
#1 Sq Drive too small for a deck screw !
By ! & * ?
About Me Avid Do-It-Yourselfer
Comments about 10 x 2-3/4 FastenMaster Deck Screws, Gray Zinc Plated, Trim Head, Square Drive:
After 4-5 camed out I went back to using the stainless steel with a #2 square drive.
Bottom Line No, I would not recommend this to a friend
Was this review helpful? Yes / No
- You may also flag this review