Getting the drawer guides on one side to match the drawer guides on the other side involves either a lot of measuring, or a lot of luck. Make it easy on yourself with this innovative jig. This jig will allow you to drill up to four guides at a time. Just set the jig rails in position, tighten them down, drill two mounting holes for each drawer, then flop the jig over, position it on the other cabinet divider, and drill the other set of holes. The jig extends 10-1/2'' into the drawer. Works with all brands of full or partial extension drawer guides. Designed for use with a user supplied Euro-Bit Self-Centering bit & bit holder. Made in USA.
Note: Picture only shows jig using 1 template, but 4 templates are actually included so that you can drill up to four guides at one time.