Prevent oxygen and moisture damage when storing your leftovers. Use inert gas when you store your leftover fine finishes, oil based paints, oil based stains, varnishes, paste wood fillers, polyurethanes, resins and glues. Normally, oxygen and moisture attack leftovers and form a “skin” on top or thicken these products. With Bloxygen, just spray, seal, and store: blast some Bloxygen under the lid, seal it, and you won't come back to a dried up blob. Bloxygen uses a powerful but natural (and ultra pure) inert gas called argon. Argon is a heavier gas so it forms a barrier between the product and the oxygen that causes problems. A single can will work about 75 times in quarts (2 second shot) or about 35 times in gallons (4 second shot) so less than 15 cents will save a $20 - $50 product. Made in USA.
Note: BLOXYGEN will NOT HELP problems with WATER-BASED FINISHES or LACQUER. These products don't cure via oxygen absorption.
|FINISHING PRODUCT TYPE||Additives|
|Container Size||(1) Each|
|SHIPPING RESTRICTIONS||Shipping Restrictions|