#3 x 1-15/16 in. Reduced Shank Square Drive Bit Ball Detent
Buy 6 and Save
Has your driver bit ever destroyed the wood surface around a countersunk #4 or #6 screw? Standard Power Driver bits are sometimes too large to fit into a 1/4" diameter countersunk hole to drive a recessed screw. When that happens, the driver bit body makes a mess of the wood surrounding the hole. Normally, this is only a problem when using a 1/4" diameter countersink with #4 and #6 screws.
The solution is quite simple - use a driver bit with a reduced shank. That way the bit tip can reach the screw without creating an unsightly mess.
- One-piece bits are usually a disappointing compromise between the need for a hardened tip and a durable body.
- Special Iso-Temp heat treating process makes these the toughest one piece bits available
- reduced shank nose can reach just a little farther into a countersunk screw hole without damaging the wood.
|PRODUCT GROUP||Power Tool Supplies|
|SUB-CATEGORY||Screw Driver Bits|
|DRIVE TYPE||Reduced Shank Square Drive|
|RECESS OR HEX-NUT SIZE||#3|
|QUANTITY d||Single (1)|
|REG / IMPACT||No|